I-Tech UltraView iOP40W User Manual page 12

Innovative lcd display solutions
Table of Contents

Advertisement

OP-40WT Series
This monitor is equipped with an auto-sensing power supply for
voltage ranges 100~240V, 50~60Hz. Please follow the following
instruction to install LCD monitor.
Jan 05
4. Using the System
C.
Installation Procedures
1. Make sure that the system power is turned off.
2. Plug the signal cable to the signal connector at the rear of
PC and the rear of the LCD monitor.
3. Plug the power cord to the rear view of the LCD and switch
on.
4. Connect the power cord to power source.
5. Turn on the computer and the monitor.
6. Then push the OSD menu button and use the Auto Adjust
function to fine the best mode of your computer.
P.10
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UltraView iOP40W and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

This manual is also suitable for:

Ultraview iop40wtUltraview op-40wUltraview op-40wt

Table of Contents