Table of Contents
Advertisement
GB
IRE
Preparation
Mounting tools
CAUTION!
Risk of injury!
If you mount the tools incorrectly and they are therefore able to
come into contact with your hand during use, there is a risk of injury.
– Do not mount the tools such that there is a possibility of them
coming into contact with your hand. For example: Ensure that the
blades are not pointing towards your hand.
Depending on the application, mount the tools listed below:
Plunge-cut saw blade
Example of use: Sawing slots (see fig. E).
Raise the tool release lever (fig. C),insert blade
with the positioning pin on the chuck, and then tighten the quick clamp (fig. D) .
Scraper
Example of use: Removing coatings, lacquer coats or floor surfaces (see fig. E ).
Raise the tool release lever (fig. C),insert blade 10, align the saw blade hole with the
positioning pin on the chuck, and then tighten the quick clamp (fig. D)
Segment saw blade
Example of use: Flush cutting fitted door frames to length (see fig. E).
Raise the tool release lever (fig. C),insert blade 8, align the saw blade hole with the
positioning pin on the chuck, and then tighten the quick clamp (fig. D)
Sanding plate
Example of use: Grinding surfaces in inaccessible corners (see fig. E).
1.
Raise the tool release lever (fig. C),insert blade 9, align the saw blade hole with
the positioning pin on the chuck, and then tighten the quick clamp (fig. D)
2.
Place the sanding sheet
Push firmly so that the Velcro backing holds in place.
Place the accessories on the tool holder at any angle (see fig. F and fig. G).
15
www.coreservice.co.uk
on the sanding plate so that they are aligned.
11
300W multifunctional tool
or
, align the saw blade hole
7
13
AFTER SALES SUPPORT
GB
+44 (0) 1904 727501
IRE
+353 (0) 19022605
Advertisement
Table of Contents
