Troubleshooting - ALDI FERREX 300W Original User Manual

GB IRE
Repairs

Troubleshooting

Some problems may be caused by minor faults that you can fix yourself. To
do so, follow the instructions in the following table.
If it is still not possible to resolve the problem with the multifunctional tool,
contact After Sales Support.
Problem
1. The multifunction-
tool cannot be
switched on.
2. The tool holder
does not move after
switching on the
multifunctiontool.
3. The oscillation/
speed can not
be increased or
decreased.
19
www.coreservice.co.uk
Possible cause
The socket has no
power.
The mains plug
has not been inserted
properly.
The mains plug has not
been inserted in the
socket.
The On/Off switch
is stuck.
The mains plug/On/Off
switch is defective.
There is dirt, wood
chips or other objects
located in the gap of
the tool holder.
The multifunctional tool
is defective.
The speed control
is dirty.
300W multifunctional tool
Solution
– Check the socket by
connecting another device.
– Check to make sure that
the mains plug is properly
seated.
– Insert the mains plug in a
socket.
– Keep the On/Off switch clean
3
as described in the chapter
"Cleaning and maintenance".
– Contact the After Sales
Support of the manufacturer.
– Pull the mains plug out of
the socket and clean the
gap of the tool holder with a
vacuum cleaner if necessary.
– Contact the After Sales
Support of the manufacturer.
– If necessary, clean the speed
4
control and the gap with a
vacuum cleaner.
GB +44 (0) 1904 727501
AFTER SALES SUPPORT
IRE +353 (0) 19022605