SiAECOSYS VOTOL EM Program Manual page 11

SiAECOSYS
3. The setting
1. SETTING PAGE 1
1.Undervoltage,overvoltage
selected by default +1V
2.overvoltage selected by
default+2V
Busbar current≤ECU Specification
current value
No change allowed
Steps to connect the upper
1. Power on the controller,Connect the
adapter cable and plug it into the computer
2.Open the upper computer debugging interface, as shown in the figure above. In the setting
interface 1,
serial port.
corresponding number will pop up here and the connection success data will pop up. The
connection is successful.
1.1：Voltage equipment
1.1.1、Battery voltage setting: Corresponding to the ECU voltage, o
10-200, the larger the looser the inertia is
COM3
Connected
computer：
click to search again.
The device status shows that it is
electric door lock, connect the serial port to the controller
After the com? Appears on
connected.
11
Usually 0
does not change
0-350, the larger the start
delay, the more obvious
10-250, the greater the
acceleration, the faster
the device port, click to
Click to connect the controller.
ver pressure is not allowed
V2
1. CAN debugging Switch
2. Chinese/English Switch
21
open the
The
.