Fisher & Paykel WH1060P Installation Manual/User Manual page 13

Electrical connection
This appliance must be connected to a 220V – 240V, 50Hz, sinusoidal, minimum 10A
z
electrical supply.
Check the power cord for damage and make sure it is not squashed or twisted when
z
installing the washer.
Always remove the power cord from a socket by the plug, not by the cord.
z
Spare Parts
SPARE PART*
Hose inlet long (2m)
Hose inlet large bore
* Available from your Fisher & Paykel dealer or a Fisher & Paykel trained and supported service technician
Complete your installation
Turn on the water and check all hose connections for leaks. Make sure there are
z
no kinks in the hose(s). Check the hose connections for leaks again after 24 hours.
Uncoil power cord, remove and discard the plastic pin cover, and plug into
z
the wall socket.
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
z
Test cycle
Your washer must be correctly installed before use. To check the installation and operation
of the washer follow the steps below:
1
2
INSTALLATION GUIDE
Press
Select a
empty and the door closed.
to activate your washer.
cycle. Ensure the drum is
QUICK
PART NO.
422680P
426123P
13