EUPA AP0 User Manual page 71

Control types and names might vary. The common types are listed below:
•
Vol: The master control for all outputs. The strength of an output signal is
determined by both the Vol slider and the slider for the individual output.
To affect all outputs, move the Vol slider. To change the output of an
individual output type, move its slider.
•
Line-in/Rear: Controls the audio hardware's Line In or Line Out levels.
Line levels might be for an externally attached cassette player, for
instance, while the four speakers' mode is enabled, this control becomes
the Rear speaker volume control.
•
Mic: Controls the microphone-input level.
•
Wave: Controls wave (voice) playback or the recording levels.
•
FM: Controls the FM music playback or the recording level.
•
Aux-in: Controls the Aux-in music play or the recording level.
•
PC-SPK: Controls the external PC speaker input level.
•
CD: Controls the CD drive output level, for CD drives configured to play
their audio output through the PC's audio hardware.
•
4SPK: Turn on or turn off the Rear speakers' effect.
•
Surround: Turn on or turn off the 3D surround sound effect.
•
SPDIF-in: Turn on or turn off the SPDIF digital signal input.
Mute Buttons: Toggle between muting and enabling the signal. A button with
a lit LED is enabled, and when it is not lit, it means it is mute. Several output
signals can usually be enabled at once.
IV.BIOS/SOFTWARE UTILITY
AP0 USER'S MANUAL
4-7