Needle Bar-Presser Unit Assembly - promelectroavtomat XL2120 Service Manual

Disassembly Procedure

Needle Bar-Presser Unit Assembly

1. Remove the needle bar crank rod.
2. Remove the screw (screws pan (S/P washer) M 3 × 8DB) of the stud for thread take-up lever supporter by
pulling it out to the right, and them remove the thread take-up lever supporter and the dome spring washer.
3. Remove the thread take-up lever body and the needle bar crank from the thread take-up lever supporter.
4. Remove the screw and the spring at the top of the needle bar supporter and remove the needle bar supporter
from the base holder assembly.
4
2 - 5
2
2
www.promelectroavtomat.ru
2
2
2
3
4
4
4
1