Assembly Procedure
Assembly Procedure
Assemble and install the units first before attaching the front cover and the rear cover
Front Cover
1. Insert the thread tension dial into the square hole of the front cover, set the thread conductor, and secure with
the two screws (taptite, bind B M 4 × 12).
2. Insert the tip of the wire of the thread conductor B assembly by aligning it against the positioning groove of
the front cover and secure with the screw (taptite, bind B M 4 × 12) that sets the protrusion of the thread
conductor B into the hole in the front cover.
2
2
2 - 9
1
1
1
www.promelectroavtomat.ru