Table of Contents
Advertisement
Adjustment
9. Adjustment of the Feeding for BH Right Over Edging
(Adjustment of Satin Feeding)
• The number of stitches of right over edging for every 20 mm should be 35 to 45.
1 Attach a J presser foot, lower the presser lever, and attach a cover.
2 Turn the selection dial to select the BH right over edging (BH d).
3 Set the slit for fine adjusting knob to vertical position.
4 Insert a piece of paper under the BH presser foot.
5 Turn the pulley to pierce the paper with the needle and take a measurement for verification.
6 Loosen the screw (Screw, pan (S/P washer) M 3 × 8) within the selection dial. (Upper center screw)
7 Tighten the screw (Screw, pan (S/P washer) M 3 × 8) within the selection dial. (Upper center screw)
8 Turn the pulley to verify that the stitches are within criteria.
20mm
40 ± 5 Needle
www.promelectroavtomat.ru
3 - 9
Advertisement
Table of Contents
