Rear Cover - promelectroavtomat XL2120 Service Manual

Assembly Procedure

Rear Cover

1. Temporarily fasten the lower thread guide assembly with the one screw (giza tite 5 × 16).
2. Insert the spool pin into the rear cover and then attach the spool pin spring onto it.
3. Attach the adjusting plate, Plate apring, and the adjusting screw in this order and secure them with the two
screws (taptite, bind B M 4 × 10).
4. Place the foot of the motor holder underneath the motor and secure it with the two screws (one giza tite 3 ×
10, and two giza tite 5 × 16).
5. Fasten the three pole socket assembly with the screw (pan head screw with spring and plain washers, size 3 × 20).
6. Route and connect the lamp unit harness.
7. Secure the bobbin assembly with the two screws (giza tite 5 × 16).
8. Fasten the cord retainer and the thread winding spring with the one screw (giza tite 5 × 16).
1
1
6
6
3
www.promelectroavtomat.ru
3
3
3
3
3
2
2
7
5
5
4
4
4
4
7
7
8
8
8
5
4
4
4
2 - 10