Table of Contents
Advertisement
Migration from Release 9.5 or 9.6 to Release 9.8 without Platform Changes
Restoring Data Files
Follow these instructions to restore the Cisco PGW 2200 Softswitch configuration files (MGC.tar) on
PGW host 2:
Step 1
Log in as root and move the Cisco PGW 2200 Softswitch configuration files to the /tmp directory.
# cd /var/tmp
Create a mount point.
Step 2
# mkdir saved
# cd /var/tmp/saved
Store the data files:
Step 3
a.
b.
Use the binary mode of ftp to transfer the MGC.tar and ttbackup.tar files.
Note
Verify that the files successfully transfer to the remote file server before continuing.
Step 4
Create an MGC directory and extract Cisco PGW 2200 Softswitch data files:
Step 5
# cd /opt
# mkdir CiscoMGC
# cd /opt/CiscoMGC
# mkdir snmp
# cp /var/tmp/saved/MGC.tar MGC.tar
# tar xvf MGC.tar
# mkdir local
# cp /var/tmp/saved/ttbackup.tar ./local/ttbackup.tar
Step 6
Verify that the etc and dialPlan directories are present.
Step 7
If you saved the snmpd.cnf file, copy the file to the /opt/CiscoMGC/snmp directory:
# cp /opt/CiscoMGC/dialPlan/snmpd.cnf /opt/CiscoMGC/snmp
Step 8
Enter the following command to reboot the Cisco PGW 2200 Softswitch:
# init 6
Installing and Verifying the Cisco PGW 2200 Softswitch Software
Follow these steps to install the Cisco PGW 2200 Softswitch software on PGW host 2:
Install the Cisco PGW 2200 Softswitch software using the instructions in the
Step 1
Cisco PGW 2200 Softswitch Software Release 9.8 and Higher Releases" section on page
When the installation is complete, perform the following steps on PGW host 2:
Step 2
Log into PGW host 2 as mgcusr.
Step 3
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
5-10
Local tape drive—Store the files on a local tape drive.
# tar xvf /dev/rmt/0
Remote file server—Using the ftp utility, transfer the MGC.tar and ttbackup.tar files from the
remote file server to the /tmp/saved directory.
Chapter 5
Migrating to Solaris 10 and Cisco PGW 2200 Softswitch Software Release 9.8
# Create MGC directory
# Create snmp directory
# Extract MGC data files
# Create snmp directory
"Installing the
3-3.
OL-18083-14
Advertisement
Table of Contents
