Parameters Required For Initial Setup - Cisco PGW 2200 Software Installation And Configuration Manual

Initial Cisco PGW 2200 Softswitch Software Configuration
Table 4-3
Parameter
engine.SysVirtualSwitch
pom.dataSync

Parameters Required for Initial Setup

The following table lists the parameter values that must be defined during the initial installation.
Note These parameters are located at the top of the XECfgParm.dat file, thus making it easier to find the
parameters required for initial setup.
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
4-8
Configuration Parameters (continued)
Description
Indicates whether the Cisco PGW 2200 Softswitch host
functions as a signaling controller or a virtual switch
controller.
Values:
•
•
Default: 0
Note
Note
Indicates that the Provisioning Object Manager (POM)
should synchronize the provisioning data at startup.
Values:
•
•
Default: False
Chapter 4 Configuring the Cisco PGW 2200 Softswitch Software
0—Signaling controller (nailed trunks, no auditing
is initiated)
1—Virtual switch controller (switched trunks)
During the startup of the
Cisco PGW 2200 Softswitch software, this
parameter is be set automatically to tune the
system for optimal performance.
For Release 9.4(1) and later, the values of the
parameters listed below are automatically set
based on the Cisco PGW 2200 Softswitch type
you select, to maximize performance for that
configuration. Any attempt to change the values
of these parameters is overwritten.
engine.SysMdlMemoryReduction
engine.CALL_MEM_BLOCK_SIZE
engine.CALL_MEM_CHUNK_SIZE
*.CPUTimerInterval
*.numberOfThreads
True— POM does not synchronize provisioning
data at startup.
False— POM synchronizes provisioning data at
startup.
OL-18083-14