Table of Contents
Advertisement
•
Using the RS232 Serial Port
Connect null-modem/crossover serial cables to the RS-232 port of spine 1. If using a terminal emulation
Step 1
device, the settings should be:
Power up the switch.
Step 2
The system prompts for a user name. In order to change the IP address and default gateway, the user must
Step 3
be logged in as the administrator. At the prompt enter:
The system prompts for a password. At the prompt enter:
Step 4
The system responds with:
To change the SFS 7012 default IP address enter:
Step 5
where -h ipaddress is the new IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx) format, and -m
netMask is the new subnet mask in dotted decimal (i.e., xxx.xxx.xxx.xxx) format.
To change the SFS 7012 default gateway IP address enter:
Step 6
where -h ipaddress is the new default gateway IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx)
format.
To to exit the CLI enter:
Step 7
Using Telnet or SSH
Power up the switch.
Step 1
Connect a Category 5 or 6 (Cat 5/6) Ethernet cable to the RJ-45 connector on spine 1. Connect the other
Step 2
end of the Cat 5/6 to an OOB LAN Ethernet hub or Ethernet switch where a work station can access the
7012. A work station can be connected directly to the Ethernet port of spine 1 of the 7012 if using a
crossover Ethernet cable. Power up the switch.
Access the switch with the following command:
Step 3
The system prompts for a user name. In order to change the IP address and default gateway, the user must
Step 4
be logged in as the administrator. At the prompt enter:
The system prompts for a password. At the prompt enter:
Step 5
Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
1-22
Use the Chassis Viewer GUI from a system that can reach the chassis using the default IP address
(192.168.100.9).
8 data bits
–
no parity bits
–
1 stop bit
–
57.6K baud
–
Use VT100 emulation.
–
Flow control = XON/XOFF
–
super
super
Welcome to the SFS 7012 CLI. Type 'list' for the list of commands.
setChassisIpAddr -h ipaddress -m netMask
setDefaultRoute -h ipaddress
logout
telnet 192.168.100.9
super
OL-8787-05
Advertisement
Table of Contents
