Troubleshooting - Fisher & Paykel DCS BE1-48R Installation Manual/User Manual

Before calling for service
If the grill does not function properly, use the following checklist before contacting your dealer for
service. You may save the cost of a service call. Troubleshooting is for general purposes only. If the
problem persists and you feel you require service, contact your dealer or the nearest authorized
agency to perform service. Only authorized agencies can perform warranty service. Contact DCS at
www.dcsappliances.com
PROBLEM
Grill won't light when the
control knob is pushed
Low heat with knob in "HI/
SEAR" position
Burner flame is yellow or
orange in conjunction with
the odor of gas
Rotisserie wont hold flame
once button is released
Dial lights and grill lights
don't turn on
Internal light not working
44

TROUBLESHOOTING

POSSIBLE CAUSES
y Gas supply is turned off
y Power supply is off
y Grill may be in a dusty area
y If using LP gas, tank may be
empty
y If only one burner is low, a port
may
be obstructed
y Gas supply is turned off
y
y Power supply is off
y GFI has tripped (Ground Fault
Interrupter)
y Transformer fuse has blown
y Bulb has blown
WHAT TO DO
y Check gas supply,
y Check that the grill is
connected to a live AC
power source
y Check GFI outlet, reset if
tripped
y Check power supply fuse,
replace if blown
y Move to a less dusty area if
possible
y Check gas supply
y See page 41 for instructions
on cleaning the orifice and
burner
y Preheat grill for a full 15
minutes
y Check gas supply
y Check that the grill is
connected to a live AC
power source
y Check GFI outlet, reset if
tripped
y See page 36 for instructions
on manually lighting the
rotisserie
y Continue holding safety
valve button in depressed
position until burner remains
lit when released
y Check that the grill is
connected to a live AC
power source
y Check GFI outlet, reset if
tripped
y Check power supply fuse,
replace if blown
y Remove glass lens, replace
with 12v G4 halogen bulb