Lamp Replacement (Center Mullion) - Hussmann Innovator Installation And Service Manual

Innovator Door Installation and
Service Instruction
WARNING
!
Always disconnect the electrical power at the
main disconnect when servicing or replacing
any electrical component. This includes, but is
not limited to, such items as doors, lights,
fans, heaters, and thermostats.
LAMP (CENTER MULLION)
REPLACEMENT
Note: No additional parts need to be removed to
change out the lamps
1. Turn off lights at switch.
Light
Switch
Reach-in models manufactured with Innovator
or Innovator II doors have anti-arc ballast.
When re-starting lamps, turn power off then on.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A. • WWW.HUSSMANN.COM
2. Disengage the diffuser clips from the mullion
by squeezing the diffuser cover at the clips. Two
hands may be required as shown in Figure 19.
Squeeze
Here
Figure 19. Disengaging Diffuser Clips
3. Raise the diffuser slightly upward and out of
the bottom filler. Twist the bottom of the diffuser
toward the shelf and center of the door while
lowering slightly to clear the honeycomb
retainer. Pull the top of the diffuser toward the
P/N 0425683F
Diffuser Clip
11