Humminbird 931C Installation And Operation Manual page 14

93x_Man_531370-1_A - vs4.qxd 2/18/2005
7. While holding cables in place in the cable collector insert, thread the cables
through the slot in the bottom of the cable collector cover, line up the cable
collector insert and cover, then slide the cover into place on the insert.
NOTE: The tab on the cable collector insert goes into the slot on the cover.
8. Attach the cable collector insert to the cable collector cover using the 2 Phillip
screws provided.
9. Plug the cable collector assembly into the back of the control head. Cable
connectors and cable sockets are keyed to prevent reverse installation, so be
careful not to force the connectors into the wrong sockets. Once the cable
collector and all cables are plugged into the back of the control head, lock the
assembly into place by threading the knurled screw into the threaded insert on
the back of the housing. (Cable ties are provided to help you secure the cables in
place by threading them through the available holes on the in-dash bracket).
NOTE: It is very important that the cable collector is used and secured in place in the In-Dash
installation.
Plug Cable Connector Assembly to
Back of Control Head
11:11 AM Page 14
1
2
3
4
5
3
9
1 2 3 4
Power
Temperature
5
Communications
Transducer
Cable Collector Insert
1
5
1 Cable Collector Insert
2 Screws
3
Cable Collector Cover
4
Tab on Insert
5 Slot on Cover
2
4