Hand Held Installation Instructions - MATHERS CONTROLS MicroCommander Installation Instructions Manual

Please contact Mathers Controls for support information.
0670
event of a change of engine speed, gear, rudder position or any
combination of these that causes you to stumble or fall, perhaps
even overboard, the safety lanyard should cause the locking key
to pull out of the back of the Hand Held Remote, putting the
engines into idle and gear shift into neutral.
• Do not attempt to operate the Hand Held Remote out of the
holding bracket in heavy weather unless you are securely
positioned in such a way to prevent any vessel motion from
throwing you off balance, or otherwise interfering with the safe
operation of the vessel controls.
• If the locking key (on the safety lanyard) is pulled out of the
Hand Held Remote, the engine(s) will go to neutral and idle. To
regain control, replace the locking key, position the control knob
to neutral, and depress the station transfer button. The Hand
Held Remote will not operate without the locking key in place.
18.3 H H
AND ELD
The Hand Held Remote is supplied with a 60 foot
that is pre-wired from the Hand Held Remote to the Distribution
Box (see Figure 22). The Distribution Box is water resistant but
THIS PRODUCT IS INACTIVE!
Figure 21 – Safety Lanyard
I
NSTALLATION
I
NSTRUCTIONS
Page 52
cable
(18,3m)