Throttle Cable Adjustment - MATHERS CONTROLS MicroCommander Installation Instructions Manual

Please contact Mathers Controls for support information.
B) Adjust the clutch cable ball joint at the transmission to
C) Move the control head lever to the 'AHEAD' detent.
D) Measure the clutch lever movement from 'AHEAD' to
E) Match the required movement and then check the

5.3.2 Throttle Cable Adjustment

A) Check that potentiometers R7 and R8 are in the fully
CAUTION: Potentiometers can be damaged by turning too hard against the stop.
B) Measure the throttle movement at the engine from
THIS PRODUCT IS INACTIVE!
match the clutch lever in 'NEUTRAL'. The push-pull
cable should form a right angle (90E) with the shift
lever in the 'NEUTRAL' position. Leave the cable
disconnected.
The Actuator can be adjusted for a total clutch
movement of 2"
shipped with switches set for minimum movement.
'ASTERN' detent. The lever movement must be within
the adjustment range of 2"
SW1 will increase the clutch movement in each
direction from 'NEUTRAL' by moving the switches from
'ON' to 'OFF'.
Switch 1 1/4"
Switch 2 1/8"
Switch 3 1/16"
'ASTERN' direction. Recheck 'AHEAD', 'NEUTRAL', and
'ASTERN' with the clutch cable disconnected. Confirm
that the Actuator does not jam the clutch lever against
its stops and that 'NEUTRAL' is correct. Connect the
clutch cable.
counterclockwise position, as shipped from the factory.
'IDLE' to 'FULL'. It must be within the Actuator range
to 3"
(51mm) (76mm).
(51mm)
(6,4mm)
APPROXIMATE DIMENSIONS
(3,2mm)
(1,6mm)
Page 18
The Actuators are
to 3"
(76mm).