Table of Contents
Advertisement
Rack-Mounting the Cisco SFS 7000P Switch
Rack-Mounting the Switch
Step 1
Step 2
Step 3
Step 4
Step 5
Installing the Switch with One Person
Step 1
Cisco SFS 7000P Hardware Installation Guide
2-6
To rack-mount the Cisco SFS 7000P switch in a rack, follow these steps:
Remove the switch, rack brackets, CD-ROM, parts bag, and documentation from
the box.
Place the switch on a secure, clean surface.
Open the plastic bag containing mounting parts.
Check the slot in the rack for sufficient clearance.
Determine the desired method of installation:
•
Installing the Switch with One Person, page 2-6
Installing the Switch with Two People, page 2-11
•
The following method of installation is easier with two people, but can be
accomplished with one person. It can be difficult for only one person to align the
switch correctly along the rack rails.
To install the switch with one person, follow these steps:
Separate one set of the rack brackets (see
Each side is assembled to its counterpart, but should be separated before attaching
to the switch when you use this method of installation.
Chapter 2
Installing the Cisco SFS 7000P Switch
Figure
2-2).
OL-9167-01 Rev. A0
Advertisement
Table of Contents
