Fisher & Paykel DE4024P1 Installation Instructions Manual page 36

PROBLEM
Greasy spots on
clothes.
Lint on clothes.
Static occurs.
Collars and
waistbands still
wet at end of
cycle.
Slight variation in
metallic color.
Dryer continues to
tumble.
34
TROUBLESHOOTING
POSSIBLE CAUSES
Improper use of fabric
softener.
Drying dirty items with
clean ones.
Clothes were not completely
clean.
Lint filter is full.
Improper sorting.
Static electricity can attract
lint.
Overloading.
Paper, tissue, etc, left in
pockets.
No fabric softener was used.
Overdrying.
Synthetics, permanent press
and blends can cause static.
The dryness monitor senses
that the body of the clothes
is dry.
This is normal.
'Wrinkle Free', 'Extra' was
selected.
WHAT TO DO
Follow directions on fabric softener
package.
Use your dryer to dry only clean
items. Dirty items can stain clean
items and the dryer.
Sometimes stains which cannot
be seen when the clothes are wet
appear after drying. Use proper
washing procedures before drying.
Clean lint screen before each load.
Sort lint producers (like chenille)
from lint collectors (like corduroy).
See suggestions in this section
under 'Static occurs'.
Separate large loads into smaller
ones.
Empty all pockets before laundering
clothes.
Try a recommended fabric softener.
Try a recommended fabric softener.
Adjust setting to a lower dryness
level.
Try a recommended fabric softener.
Choose 'Time Dry' to dry damp
collars and waistbands. In the future,
when drying a load with collars and
waistbands, choose a higher dryness
level.
Due to the metallic properties of
paint used for this unique product,
slight variations of color may occur
due to viewing angles and lighting
conditions.
Ensure 'Wrinkle Free', 'Extra' option
is not selected.