Fisher & Paykel DE4024P1 Installation Instructions Manual page 34

PROBLEM
No numbers
displayed during
cycle, only lights.
'TIME TO GO'
jumped to a lower
number.
Cannot make a
selection and the
dryer beeps twice.
Dryer is running
but is
displayed in 'TIME
TO GO'.
Clean lint filter
(message).
Dryer doesn't
heat.
Inconsistent
drying times.
Glow at the rear
of the drum.
32
TROUBLESHOOTING
POSSIBLE CAUSES
Dryer is continuously
monitoring the amount of
moisture in the clothes.
The estimated time may
change when a smaller load
than usual is being dried.
The dryness level,
temperature, or option that
you are trying to select
is incompatible with the
chosen dry cycle.
The 'Wrinkle Free', 'Extra'
option was chosen.
'POWER' button was
activated.
Fuse is blown/circuit
breaker is tripped; the dryer
may tumble but not heat.
Type of load and drying
conditions.
Excess debris has collected
in the condenser preventing
proper airflow.
Heaters behind the drum.
WHAT TO DO
This is normal. When the dryer
senses a low level of moisture in the
load, the dryer will display the dry
time remaining.
This is normal.
This is normal.
This is normal. During extended
tumbling, the time remaining is not
displayed.
Press to begin a dry cycle and
the message will disappear.
Check the building's fuse/circuit
breaker box and replace both fuses
or reset both breakers. Your dryer
may tumble if only one fuse is
blown or one breaker tripped.
The load size, types of fabric,
wetness of clothes and the condition
of the lint filter, condenser, and/or air
intake vent located on the front of
the dryer will affect drying times.
Refer to the 'Caring for your dryer'
section.
This is normal. Under certain drying
conditions and room ambient
lighting, the glow of the heaters may
be visible at the rear of the drum.