Fisher & Paykel DE4024P1 Installation Instructions Manual page 33

PROBLEM
The 'Dry' dryness
level was chosen
but load is still
damp.
Control buttons
not responding.
Dryer doesn't
start.
TROUBLESHOOTING
POSSIBLE CAUSES
Load consists of a mixture
of heavy and light fabrics.
Lint filter, condenser, and/
or air intake vent located
on the front of the dryer is
blocked.
Dryness sensors are dirty.
Controls accidentally put in
service mode.
Controls accidentally put in
'Keylock' mode.
Controls performed an
incorrect operation.
Control panel is "asleep".
Dryer is unplugged.
Fuse is blown/circuit
breaker is tripped.
Dryer was accidentally
paused when starting 'Delay
Start'.
Water tank is full.
WHAT TO DO
When combining heavy and light
fabrics in a load, choose a higher
dryness level.
Inspect and clean lint filter,
condenser, and/or air intake vent
located on the front of the dryer.
Clean the sensors with a moist cloth.
These are the metal ribs located in
the drum behind the lint filter.
Press .
Hold the button for 3 seconds to
unlock the dryer.
Check the building's fuse/circuit
breaker box and replace fuse or
reset breaker. Note: electric dryers
use two fuses or breakers.
This is normal. Press 'POWER' to
activate the control panel.
Make sure the dryer plug is pushed
completely into the outlet.
Check the building's fuse/circuit
breaker box and replace fuse or
reset breaker. Note: electric dryers
use two fuses or breakers.
If the light on the
flashing, the dryer is paused. Press
to restart the countdown.
If the 'Water Tank' light is on, you
must empty the water tank before
the dryer will start. Refer to the
'Caring for your dryer' section
for instructions on emptying the
water tank.
EN
button is
31