Fisher & Paykel DE4024P1 Installation Instructions Manual page 17

Connecting the drain hose
Draining water without using the water tank
You can use the dryer without using the water
tank by following the procedures below.
To connect the drain hose:
Disconnect the drain hose A.
1
Connect the drain hose A to the other hole.
2
Connect accessory hose B (long drain hose)
3
adjacent to hose A.
When connecting hose B, take care that
● ●
the height of the hose does not exceed
58" (147cm).
After connecting the drain hose, you can
● ●
now directly drain the condensed water to
a standpipe or washstand.
Over the edge of a wash basin: The
4
drain hose must be placed lower than
58" (147cm). To keep the drain hose
spout bent, use the plastic hose guide
as supplied with the washer. Secure the
guide to the wall with a hook or to the
tap with a piece of string to prevent the
drain hose from moving.
Assemble the drain hose and the hose
5
guide and fix them with the cable-tie.
Do not push the drain hose in the
standpipe any further than 4" (10cm).
Pushing the drain hose further in the
standpipe can cause leaking.
INSTALLATION INSTRUCTIONS
Back view
Drain hose Hose guide
Cable ties
EN
A
A
B
58"
(147cm)
Max.
15