Installation Considerations; Tools Required - Fisher & Paykel OB60SC5LB Installation Manual

INSTALLATION CONSIDERATIONS

Before installation, please ensure the following:
The countertop and oven cavity are square and level, and are the required dimensions.
z
The installation will comply with all clearance requirements and applicable standards and
z
regulations.
The isolating switch will be easily accessible to the customer with the oven installed.
z
The electrician provides sufficient free length of power supply cable to reach from the
z
bottom rear of the cavity to at least 1.5 metres in front of the bottom edge of the opening.
The cable may enter the cavity from the side, top or bottom, but top entry must be at the
z
rear of the cavity.
The oven connection socket (if fitted) is outside the cavity if the oven is flush to the
z
rear wall.
The oven will rest on a surface that can support its weight.
z
The height from the floor suits the customer.
z
You consult local building authorities and by-laws if in doubt regarding installation.
z
Some environmental factors and cooking habits can cause condensation in and around the
oven during use. To protect surrounding cabinetry from possible damage caused by frequent
or excessive condensation, we recommend moisture-proofing the oven cavity.
During installation, please ensure the following:
The oven door can open fully without obstruction.
z
The power supply cable does not touch any hot metal parts.
z
The isolating switch is easily accessible to the customer with the oven installed.
z
You complete the 'Final checklist' at the end of the installation.
z
If, after following the instructions given, correct performance cannot be achieved, please
z
contact your Fisher & Paykel trained and supported service technican or Customer Care.
COMPONENTS REQUIRED
PARTS SUPPLIED
Screws (2) Metal side shelves
fixing nut (2)

TOOLS REQUIRED

Crosshead Power drill
screwdriver
Scissors
3