Fisher & Paykel WH9060J Installation Manual/User Manual page 7

Do not overload your washing machine beyond its rated capacity.
z
MODEL
WH7560P, WH7560J
WH8060F, WH8060P, WH8060J
WH8560F, WH8560P, WH8560J
WH9060J
Do not wash an electric blanket in your washer unless the care label specifically states
z
it is safe to do so.
Do not wash curtains in this washer, as sunlight makes them brittle and they may
z
disintegrate during washing.
The only user-removable parts of the washer are the inlet hose(s), detergent dispenser
z
and the pump filter. No other parts are designed to be removed by anyone other than a
Fisher & Paykel trained and supported service technician.
Installation
For guidance on how to install your product, please refer to installation instructions
z
contained in this document.
Water supply requirements:
Inlet water pressure: Maximum 1MPa (145psi), Minimum 30kPa (4.5psi)
z
Inlet water flow rate: Minimum 6 litres/minute
z
New hose sets provided with the washer should be used to connect the washer to the
z
water mains. Old hose sets should not be re-used.
We recommend the inlet hose(s) are changed every 5 years. WARNING: Failure to do so
z
may result in a flood and damage to property.
The hot water temperature should not exceed 65°C and the cold water temperature
z
not exceed 35°C. Temperatures above these may cause the machine to fault or cause
damage to the machine.
Install the machine on a solid and level floor surface ensuring it has at least 20 mm
z
clearance on each side. The washer must not be installed on any textured floor
coverings (eg carpet, rugs).
Disposal
When disposing of the washer, it is recommended that the door is removed to
z
avoid children getting trapped inside, and that the electrical cable is cut off
close to the washer.
SAFETY AND WARNINGS
MAX CAPACITY
7.5Kg
8.0Kg
8.5Kg
9.0Kg
Note:
Capacity refers to the maximum
z
dry weight of items the washer
can wash at any one time.
5