Bin Master C-100-R Operator's Manual page 8

Modbus console
Table of Contents

Advertisement

3.1.1 Screw Mount
There are three screw holes that can be used for mounting the C-100-R control console as shown in the
diagram below. You will need one #8 wood screw at least 3/8" long and two #8 wood screws at least 5/8"
long.
1. Locate, drill a hole for and screw the 3/8" long screw into the mounting board/plate, leaving the
head of the screw out about 1/8".
2. Hang the console with the one screw by the center mounting tab.
3. Remove the lower wiring cabinet cover and mark the locations for the two lower mounting screws
with a pencil or awl.
4. Remove the console and drill holes for the two lower mounting screws.
5. Hang the console again by the center mounting tab and fasten in place with the two lower mounting
screws.
925-0389 rev A
8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the C-100-R and is the answer not in the manual?

This manual is also suitable for:

Smartbob c-100

Table of Contents