Table of Contents
Advertisement
RS9120W models only
To clean the toe kick grille and filter:
Remove the air flow divider by pulling
1
towards you (A).
To remove the top toe kick grille, insert
2
fingers into the left and right square
openings on the grille. Pull towards
you (B).
To remove toe kick filter, insert fingers
3
into the left and right square openings
on the filter. Pull towards you. Refer to
'Removing and replacing toe kick filter'
drawing.
Clean both components with liquid
4
dishwashing detergent dissolved in
warm water and a soft lint-free cloth.
Rinse with clean water and dry with a
5
clean, lint-free cloth.
To replace toe kick filter and
toe kick grille:
To replace toe kick filter, align filter tabs
6
onto the rails and push to the rear until
it clips securely.
To replace top toe kick grille, align
7
securing hooks then firmly push grille
onto product until it clips securely (C).
To replace air flow divider, align the
8
divider underneath the grille tabs
indicator and clip onto the vanes of the
bottom grille (D).
CLEANING CARE
Removing air flow divider
Removing top toe kick grille
Replacing top toe kick grille
Replacing air flow divider
A
1.
IF TOEKICK IS HIGHER THAN 4" U
CUT UNREQUIRED VANES FROM
2.
DRILL HOLES THROUGH DIMPLE
3.
USE PROVIDED SCREWS TO FIX G
MATCHING HOLES ON PLASTIC
B
C
D
27
Advertisement
Table of Contents
