Reverse Channel Output; Fade Time Assign; Manual Mode - Flash F9000382 User Manual

User Manual • Instrukcja Obsługi
———⬤———

REVERSE CHANNEL OUTPUT

Action:
1) press and hold the PROGRAM button
until the led blinks
2) Press and hold FINE & MODE buttons
together to access the channel assignment
mode ,then press the SCANNER button
3) Use the Bankup/Down buttons to select
pan/tilt
4) Press the TAP/DISPLAY button to switch
between pages
5) press and hold MODE button, then press
the SCENES buttons to select the DMX
channel. AII LEDs will blink.
6) Press and hold FINE & MODE buttons (2)
times to exit
Notes:
You can permanently reverse the output of
any given channel on the controller.
Press AUTO/DEL&MODE buttons together
to delete the reverse channel.

FADE TIME ASSIGN

You can choose whether the boards fade
time during scene execution is implemented
broadly to all output channels or only to
the Pan & Tilt movement channels. flis is
relevant because often you will want gobos
and colors to change quickly while not
affecting the movement of the light.
Action:
1) Turn OFF the controller.
2) Hold the MODE and TAP DISPLAY
buttons simultaneously.
3) Turn ON the controller.
4) Press the TAP DISPLAY button to toggle
between the two modes. Either ALL CH (all
channels) or ONLY X/Y (Pan & Tilt only)
5) Press MODE and TAP DISPLAY to save
settings. All LEDS will blink to confirm.
Notes:
ALL CH: All channels ONLY X/Y: Only Pan
& Tilt
Operation

MANUAL MODE

fle manual mode allows direct control of
all scanners. You are able to move them
and change attributes by using the channel
faders and wheel.
———⬤———
Action:
1) Press the AUTO DEL button repeatedly
until the MANUAL LED is lit.
2) Select a SCANNER button.
3) Move wheel and faders to change fixture
attributes. PAGE/SELECT A/8 button:
Use to switch between fader control of
(A: Ch 1-8 ), (B: Ch 9-16)
TAP DISPLAY button:
Press to toggle the output indicator on the
LCD display between OMX values (0-255)
and percentage (0-100)
Notes:
All changes made while in Manual Mode are
temporary and will not be recorded
REVIEW SCENE OR CHASE
flis instruction assumes that you have
already recorded scenes and chases on the
controller. Other wise skip section and go to
programming.
Action: (SCENE Review)
1) Select any one of the 30 banks by pressing
the BANK UP/DOWN buttons.
2) Select a SCENE button (1-8) to review.
3) Move wheel and faders to change fixture
attributes.