Flash F9000382 User Manual page 5

Item Button or Fader
1 Scanner select buttons
2 Scanner indicator LEDS
3 Scene select buttons
4 Channel faders
5 Page A Indicator LED
6 Page B Indicator LED
7 Page select button
8 Program button
Music/Bank Copy button
9
LCD display window
10
11 Mode Indicator LEDS
12 Bank Up button
13 Bank Down button
Tap Display button
14
15 Blackout button
16 Midi/Ree button
17 Assign LED
18 Auto/Del button
19 Chaser buttons
20 Speed fader
21 Fade-Time fader
22 Fine button
23 Reverse LED
PAN/TILT Wheel (Joystich)
24
25 Mode button
26 Override button
27 Fog machine button
Fog machine ready indicator
28
29 Fog machine heating indicator
30 Audio input jack
31 MIDI input port
DMX polarity switch
32
33 DMX output connector
34 DMX input connector
35 Fog machine socket
36 DC Input jack
37 USB Lamp socket
38 ON/OFF power switch
240A DMX CONTROLLER 240ch 2019 • Art No F9000382
Function
Fixture selection
Indicates the fixtures currently selected
Universal bump buttons representing scene location for storage and selection
For adjusting OMX values, Ch 1~8 can be adjusted immediately after pressing the respective
scanner select button, Ch 9~16 after pressing the Page select button
Represents Ch 1~8 range selected, Tip! Tap A, B then B again to control both pages
simultaneously.
Represents Ch 9~16 range selected
In manual mode, press to toggle between pages of control or to select both pages
simultaneously. Both LEDS on will allow control of both lower and upper range channel.
Used to enter programming mode
Used to activate Music mode and as the copy command during programming
Status window displays pertinent operational data
Provides operating mode status, (manual, music or auto)
Function button to traverse Scene/Steps in banks or chases Incremental OMX values while
FINE button is active.
Function button to traverse Scene/Steps in banks or chases Decremental OMX values while
FINE button is active.
This is a Tap-Sync during playback and during programming changes the DMX value
displayed in the LCD panel to percentages
Sets the shutter or dimmer value of all fixtures to „O" causing all light output to cease
Activates MIDI external control and also used to confirm the record/save process
Indicated the controller is in Channel assign mode during the initial setup of the controller
I Used to activate Auto mode and as the delete function key during programming
Chase memor y 1 ~ 6
This will adjust the hold time of a scene or a step within a chase
Also considered a cross-fade, sets the interval time between two scenes in a chase
Activates 16 bit control of the wheel, movement will be in extremely small increments.
Note: While FINE is active Bank UP/DOWN buttons will increase and decrease OMX values
by one for either the wheel or the slider in focus or currently moved.
Generally used to control the pan and tilt movement of a fixture
To activate the fog machine
Direct audio feed for use in sound-active mode
For external triggering of Banks and Chases using a MIDI device
May be used to correct signal polarity
DMX control signal
Used to transfer programmed data between 2 controllers
Main power feed
Turns the controller on and off