Wheel Assignment; Copy Scanner - Flash F9000382 User Manual

Please refer to your individual fixture's
manual for DMX addressing instructions.
fle table above refers to a standard 9
dipswitch binary configurable device.

WHEEL ASSIGNMENT

Because not all intelligent lighting fixtures
are alike or share the same control
attributes, the OMX-240A allows the user
to assign the wheel the correct pan and
tilt channel for every individual fixture
including 16 bit channel assignments. It
also allows the user to re-assign physical
faders to fixture OMX channels so that the
user can combine or unify control of similar
or the same attributes across different
types of fixtures.
———⬤———
Action:
1) press and hold the PROGRAM button
until the led blinks
2) Press and hold FINE & MODE buttons
together
3) times to access the channel assignment
mode. fle assign led will light. fle wheel
can be reassigned to output on a different
dmx channel.
3) press a SCANNER button that represents
the fixture you would like to set the pan &
tilt
4) Use the BANKUP/DOWN buttons to
select pan/tilt
Notes:
All wheels can be reassigned to output on a
different OMX channel.
Press AUTO/DEL&MODE buttons together
to delete the channel assignment mode.
———⬤———
Action:
5) Press the TAP/DISPLAY button to switch
pages
6) Press and hold MODE button, then
240A DMX CONTROLLER 240ch 2019 • Art No F9000382
press the SCENES buttons to select the
DMXchannel. AII LEDs will blink.
7) Press and hold FINE & MODE buttons to
exit
Notes:
You can re-assign the OMX channel to all
controller fader channels.
Review wheel assignment or reverse
Action: (Reverse Review)
1) Press and hold FINE & MODE buttons
together to access the wheel assignment
mode
2) press a SCANNER button to select a
scanner
3) Press and hold FINE & MODE buttons
together (2) times to exit
Action: (wheel assignment Review)
1) Press and hold FINE & mode buttons
together (2) times to access the channel
reverse mode
2) press a SCANNER button to select a
scanner
3) Press and hold FINE & MODE buttons to
exit

COPY SCANNER

Example: Copying Scanner 1 into Scanner 2
Action:
1) Press and hold SCANNER button # 1.
2) While holding button# 1 press SCANNER
button # 2.
3) Release SCANNER button # 1 first before
releasing SCANNER button # 2.
4) All SCANNER LED indicators will flash to
confirm successful copy.
Notes:
To save time, you can copy the settings of
one Scanner button to another.
———⬤———
———⬤———