Midi Channel Setting - Flash F9000384 User Manual

User Manual •Instrukcja Obsługi

MIDI CHANNEL SETTING

1. MIDI channel setting
I. Press MIDI, the third and fourgh digits
of LED blink, selects MIDI channel setting.
II. Press MIDI one more to end MIDI
channel setting. Also you can press any
BANK
I. Select desired CHASE
II. Press desired CHASE while holding
Auto/DEL
5. CLEAN ALL CHASE (ALL SCENES are
still availanble)
RUNNING SCENES
Turn the power on it is in MANUAL RUN mode when in PROGRAM
mode, press PROGRAM for 2 seconel PROGRAM LED goes out, it
enters MANUAL mode.
If there is not any scenes having been programmed in a bank, the
scene can't be run, only the SCENES having been programmed are
executed.
If the fades is set to OFF, Scene will execute channel program setting.
1. MANUAL RUN
I. Extinguish AUTO Triggered LED and
MUSIC triggered LED.
II. Select a bank (using ↑ or ↓ , MIDI signals
through MIDI interface)
III. Press scene to run scene.
IV. Press the SCANNER to copy to, then the
SCANNER is copied to another SCANNER.
2. AUTO RUN
I. Press AUTO/DEL, corresponding, LED is
ON.
NOTE NUMBER
other key except UP and DOWN or move
the fades to end MIDI channel setting.
2. MIDI RUNNING
NOTE ON: Receive NOTE ON signals to
execute corresponding function.
FUNCTION
I. Press DOWN+Auto/Del while turning
power off.
II. Turn the power on.
II. Press TAP SYNC/DISPLAY. Press it
once more after some time, the interval
between two bressing is assigned to the
speed of AUTO RUN, the maximum limit
is 10 minutes. If there are many pressings
more than twice, the last two pressing are
designated.
III. Select desired bank, using UP or DOWN
via MIDI signals.
IV. Press Auto/DEL once more to withdraw
AUTO RUN mode.