Starting The Pump; Setting The Clock; Selecting Speed; Default Speeds - Neptune NPVS150 Basic Operation Manual

1. STARTING THE PUMP

1.01 Press
1.02 The pump will start after controller goes through its diagnostics.
1.03 If priming function has been enabled, the pump will start on prime for the desired
timeframe set.
1.04 External and/or internal timers can now be used.

2. SETTING THE CLOCK

2.01 Whilst in display mode, short press
displayed.
2.02 Press
2.03 Press
2.04 Press
2.05 Short press

3. SELECTING SPEED

3.01 Press
the default speed.

4. DEFAULT SPEEDS

4.01 Default Speed 1500 RPM -This speed should be used for economy mode on filtration.
4.02 Default Speed 2400 RPM - This speed should be used for a majority of suction cleaners
connected to skimmer box.
4.03 Default Speed 3400 RPM - This speed should be used for backwashing sand filters and
manual vacuuming.
Neptune NPVS150 – Basic Operation Guide
. The Power light
and hold down for 3 seconds until digits flash.
to scroll right and
or to change time.
to save setting.
or or . Light will illuminate above selected speed, this will now be
will illuminate.
to cycle between displays until CL: (CLOCK) is
to scroll left between digits.
Page 3