Storage; Installation, Operation; Assembly And Connection Of Pump - Xylem LOWARA VOGEL Series Installation,Operation And Maintenance Instruction

Please
note
Please
Sling ropes must not be fixed to ends of shafts or the ring loops of the motor.
note
Do not stand underneath suspended loads; take note of the general regulations on
prevention of accidents.
The pump/pump unit must be secured against tipping over and slipping until it has
been fixed in its final location.

3.2 Storage

Pumps or pump units that are stored for a long time before use must be protected against moisture,
vibrations and dirt (e.g. by wrapping in oil paper or plastic sheeting). Pumps must basically be
stored in a place where they are protected from the weather, e.g. under cover. During this time, all
suction and discharge branches and all other intakes and outlets must be closed with dummy
flanges or plugs (see also chapter 6 – Longer periods of non operation).

4. Installation, Operation

4.1 Assembly and connection of pump

The pump and motor (= pump unit) must be provided with a shared foundation base made in steel
or cast iron or a welded steel profile frame where this does not exist already or if it is not included
in the delivery. This foundation base must be placed on a foundation which can withstand all loads
that arise during operation.
The size of the foundation and the location and size of the recesses for the foundation anchors are
given in the dimension drawing, which is binding.
Please
Sufficient space must be provided for maintenance and repair work, especially for
note
replacing the drive motor or the complete pump unit.
The motor fan must be able to take in enough cool air, and the intake grille must
therefore be at least 10 cm away from any wall, etc.
Pa 100/3-en
Operating instructions
9