YILMAZ 300 User Manual page 55

PROCESS SEQUENCE IN MANUAL OPERATION

By pressing the

conveyor support is send, is written. For example 2340 mm is entered on left area. Right window shows the current
position of the conveyor support.

The section in the middle is used for common operations. For example, if conveyor carries more than one part, the
number of materials is written in this window. When there is 3 parts on the conveyor, 3 is entered to window. In this
way the counter value increases by three after each operation. The most right window is the counter, and after each
operation, its value increases by the amount displayed in middle window.

After the required dimension is provided, conveyor support is located at demanded position by pressing the
operations.
OPERATION SEQUENCE ACCORDING TO INFORMATION OF AUTOMATIC LIST

By pressing


On the contrary to manual operation, this mode does not require to enter length or quantity information. All the
necessary information is provided by list automatically.
button, machine is taken into manual operation mode.
button. When the support reaches the desired position, then machine allows doing necessary
button, machine is taken into automatic operation (list dependant) mode.
On the left window, the value of the location, where
The demanded quantity is entered to the most left window.
55