Removal And Replacement Of Float Switch - Hoshizaki KM-1300SAH-E Service Manual

7) Remove the closed end connectors from the pump motor leads.
8) Remove the two screws and the pump motor bracket.
9) Remove the pump housing and check the impeller.
10) If the impeller is defective, install a new impeller.
11) Install the new motor or new parts, and replace the removed parts in the reverse
order of which they were removed.
12) Turn on the power supply and check for leaks.
13) Replace the front panel in its correct position.
L. Removal and Replacement of Float Switch
1) Go through the steps 1) through 6) in "K. Removal and Replacement of Pump Motor."
2) Remove the connectors of the float switch.
3) Remove the screw and the float switch bracket.
4) Remove the two screws and the float switch.
5) Take off the hose sleeving the float switch leads.
6) Sleeve the leads of the new float switch with the hose.
7) Install the new float switch, and replace the removed parts in the reverse order of
which they were removed.
8) Turn on the power supply.
40