Cleaning The Brush; Recovery Tank Cleaning - Nilfisk-Advance Advance ecoflex SC500 Instructions For Use Manual

CLEANING THE BRUSH

RECOVERY TANK CLEANING

revised 07/2017
11/2014
CAUTION!
1. Remove the brush as shown in Use/operation chapter.
2. Clean the brush with water and detergent.
3. Check the condition of the brush bristles, ensuring they are not excessively worn; if necessary, replace the brush.
1. Drive the machine to the appointed disposal area.
2. Ensure that the machine is off and the user key (52) has been removed.
3. Raise the cover (34).
4. Drain the water from the tank with the drain hose (12).
5.
and reinstall it.
6. Remove the debris collection tank (D) and open its cover, then clean it carefully and reinstall it on the vacuum hose.
7. Check the condition of the tank cover gasket (E).
NOTE
8. Check that the seating surface (H) of the gasket (E) is in good condition, clean and suitable to form a seal with the gasket
itself.
9. Close the cover (19).
It is advisable to wear protective gloves when cleaning the brush because there may be sharp debris.
Clean the vacuum grid (31), release the fasteners (A, Fig. 12), open the grid (B) and recover the float (C) then clean it carefully
The gasket (E) allows the creation of a vacuum in the tank, which is necessary to suck up the recovery water.
If necessary, replace the gasket (E) by removing it from its housing (F). When fitting the new gasket, position the joint (G) in
the area shown in the figure.
B
E
F
H
A
A
C
INSTRUCTIONS FOR USE
9099980000 - SC500
Figure 12
G
D
ENGLISH
P100851
E
H
23