Intended Use; Flush Cutting - Black & Decker BD200MT Instruction Manual

Intended use

detail Sanding
Sanding in extremely tight areas otherwise difficult to reach and require hand sanding.
Select a high oscillating frequency. Sand with continuous motion and light pressure.
Applying excessive pressure does not increase material removal; but will prematurely
wear sanding sheets.

flush cutting

Remove excess wood from door jamb, window sill and/or toe kick. Removing excess
copper or PVC pipe.
Removal Work
Carpets & backing, old tile adhesives, caulking on masonry, wood and other surfaces.
Removal of excess Materials
Tile grout, plaster, mortar splatters, concrete on tiles, sills.
Preparation of Surfaces
New floors and tiles.
functional description
(figure 1)
A) On/Off switch
B) Variable speed dial
C) Power cord
D) Clamp washer
E) Bolt
1
A
Assembly
WARNING:
assembly, adjustments or changing accessories. Such
preventive safety measures reduce the risk of starting the
tool accidentally.
WARNING:
touch workpiece or blade immediately after operating the
tool. They can become very hot. Handle carefully. Always
allow workpiece and accessories to cool before handling.
Installing/Removing Accessories
The BD200MT features an exclusive tool-free accessory
changing system. This allows for faster accessory changes
without the need for wrenches or hex keys like other
oscillating tool systems.
SAve THeSe INSTRucTIoNS
G
Disconnect the plug from the power source before making any
Risk of lacerations or burns. Do not
F) Hex wrench
G) Tool-free release
H) Adaptor plate
I) Press board
J) O-ring
B
C
6
E
D
F
I
H
2
J