Yamaha MT-09 2021 Service Manual page 55

1. Canister purge hose (purge cut valve sole-
noid to canister)
2. Starter motor lead
3. Sidestand switch lead
4. Canister breather hose
5. Fuel tank drain hose
6. Plastic locking tie
7. Stator coil lead
8. Shift sensor lead
9. Clutch cable
10. Wire harness
11. Bracket
12. Wire harness (to purge cut valve solenoid)
13. Purge cut valve solenoid coupler
14. Purge cut valve solenoid
15. Frame
16. Cylinder head
A. Connect each lead wire to the respective
couplers of the wire harness inside the boot.
B. Route the shift sensor lead on the outside of
the fuel tank drain hose and canister breather
hose.
C. The plastic locking tie position is aligned with
the end of the gray tape (shift sensor side
and sidestand switch side).
D. Gray tape of shift sensor lead and side stand
switch lead.
E. Route the stator coil lead, shift sensor lead
and sidestand switch lead on the left side of
the clutch cable and canister purge hose
(purge cut valve solenoid to canister).
F. Face the end of the plastic locking tie leftward
and cut off the excess.
G. Insert the plastic locking tie into the hole of
the bracket.
H. Arrange the sidestand switch lead to the right
side of the vehicle.
I. Arrange the shift sensor lead to the left side
of the vehicle.
J. Left side of the vehicle
K. Route the stator coil lead to the front of the
vehicle and fix the gray tape part with a plas-
tic locking tie.
L. Fix the plastic locking tie is located 20–30
mm (0.79–1.18 in) away from the plastic lock-
ing tie "6C". Face the locking part of the plas-
tic locking tie forward. Face the end of the
plastic locking tie rightward and do not cut off
the excess.
M. Right side of the vehicle
N. Front side of the vehicle
O. Route the wire harness (to purge cut valve
solenoid) on the rear side of the stator coil
lead, sidestand switch lead and shift sensor
lead.
P. Route the fuel tank drain hose on the rear
side of the stator coil lead, sidestand switch
lead and shift sensor lead. Route the fuel
tank drain hose on the left side of the canister
purge hose (purge cut valve solenoid to can-
ister).
Q. Route the clutch cable between the cylinder
head and the bracket.
2-28
CABLE ROUTING