Checking The Purge Cut Valve Solenoid; Installing The Fuel Pump; Installing The Fuel Tank - Yamaha MT-09 2021 Service Manual

EAS33542
CHECKING THE PURGE CUT VALVE
SOLENOID
1. Check:
• Canister purge hose
Loose connection → Connect properly.
Cracks/damage/wear → Replace.
2. Check:
• Purge cut valve solenoid resistance
Refer to "CHECKING THE PURGE CUT
VALVE SOLENOID" on page 8-65.
EAS30456

INSTALLING THE FUEL PUMP

1. Install:
• Fuel pump gasket
• Fuel pump
• Fuel pump bracket
• Fuel pump bolt
Fuel pump bolt
4.0 N·m (0.40 kgf·m, 3.0 lb·ft)
TIP
• Do not damage the installation surfaces of the
fuel tank when installing the fuel pump.
• Always use a new fuel pump gasket.
• Install the fuel pump gasket so that the lip side
turns to the inside of the fuel tank.
• Install the fuel pump as shown in the illustra-
tion.
• Install the fuel pump projection "a" toward the
fuel tank slot "b".
• Align the projection "a" on the fuel pump with
the slot in the fuel pump bracket.
• Tighten the fuel pump bolts in the proper tight-
ening sequence as shown.
A. Forward
New
4
1
2
3
a
EAS30457

INSTALLING THE FUEL TANK

1. Connect:
• Fuel hose (fuel tank side)
ECA17500
NOTICE
When installing the fuel hose, make sure that
it is securely connected, and that the fuel
hose connector cover on the fuel hose is in
the correct position, otherwise the fuel hose
will not be properly installed.
TIP
• Install the fuel hose onto the fuel pump secure-
ly, and slide the fuel hose connector cover "1"
in the direction shown in the illustration.
• It is prohibited to wear the cotton work gloves
or equivalent coverings.
1
2. Connect:
• Fuel tank drain hose
• Fuel tank breather hose
• Fuel pump coupler
b
7-4
FUEL TANK