P0030; Troubleshooting - Yamaha MT-09 2021 Service Manual

EAS20397

P0030

EAS33134

TROUBLESHOOTING

Item
O sensor heater: defective heater controller detected.
2
Fail-safe system
• Able to start engine
• Able to drive vehicle
Procedure
TIP
If more than one DTC is detected at the same time, perform troubleshooting of DTC listed below first.
• P0112, P0113, P0122, P0123, P0222, P0223, P2135
1. Connection of O sensor coupler.
2
• Check the locking condition of the coupler.
• Disconnect the coupler and check the pins (bent or broken terminals and locking condition of the
pins).
Is the coupler condition normal?
YES
→ Go to step 2.
NO
a. Connect the coupler securely or replace the wire harness.
b. Turn the main switch to "ON", and then check the condition of the DTC using the malfunction
mode of the YDT.
Is it in the "Recovered" condition?
YES
→ Go to step 6, and complete the service.
NO
→ Start the engine, and then check the condition of the DTC.
Is it in the "Recovered" condition?
YES
→ Go to step 6, and complete the service.
NO
→ Go to step 2.
TIP
For this check, also set the stop/run/start switch to "ON".
2. Connection of ECU coupler.
• Check the locking condition of the coupler.
• Disconnect the coupler and check the pins (bent or broken terminals and locking condition of the
pins).
9-92
P0030