Transportation And Storage; Troubleshooting; Technical Data - GreenWorks SSF405 Operator's Manual

12. Replace and tighten the remaining screws on the right
side cover.
12 TRANSPORTATION AND
STORAGE
• Clean the machine before storage.
• Make sure the engine is not hot when you stow the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Stow the machine in a locked, dry area.
English
• Make sure that children cannot come near the machine.
• When you move the machine, hold it by the top handle
and auxiliary handle.
13

TROUBLESHOOTING

Problem
The handle is not
in position.
The machine does
not start.
The engine is on,
but the impeller
does not turn.
A thin layer of
snow stays behind.
* If you cannot find the solution to these problems, call
1-888-909-6757.
14

TECHNICAL DATA

Voltage
No load speed
Clearing width
Clearing depth
Impeller size
13
Possible cause Solution
The bolts are not Adjust the height
engaged correctly. of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The battery is not Charge the battery
charged. by following the
procedures in the
battery and charg-
er manual.
The switch is de- Have the switch
fective. replaced by an au-
thorized service
center.
Battery is too cold. Remove battery
from snow throw-
er. Place battery on
charger and allow
to charge for 10
minutes or until
the changing light
turns green. Re-
move from charger
and install in snow
thrower for use.
Battery may re- Call toll free help-
quire service or re- line, at
placement. 1-888-909-6757 or
replace battery.
The belt is dam- Replace the belt.
aged.
The scraper is Replace the scra-
damaged. per.
40 V
1800 RPM
12 in (30.5 cm)
6 in (15.2 cm)
11 in (27.9 cm)
EN