Champion 201080 Operator's Manual page 25

201080 - 4650W DUAL FUEL ELECTRIC START INVERTER GENERATOR
4. Pull the recoil cord slowly until resistance is felt and then pull
rapidly.
5. Do not over-choke. As soon as engine starts, turn the EZ
Start dial to the "RUN" position.
Warm Engine Start
3. Move the EZ Start dial to the "RUN" position.
4. Pull the recoil cord slowly until resistance is felt and then pull
rapidly.
Electric Start
Cold Engine Start
3. Move the EZ Start dial to the "CHOKE" position.
4. Press and hold the yellow ignition switch on the EZ Start Dial
toward the center of the dial. Release as the engine begins to
start. If the engine fails to start within five seconds, release
the switch and wait at least ten seconds before attempting to
start the engine again.
25
OPERATION