Control Panel - Champion 201080 Operator's Manual

201080 - 4650W DUAL FUEL ELECTRIC START INVERTER GENERATOR

Control Panel

1
2
1. Intelligauge with Power Meter – See Intelligauge with
Power Meter section.
2. Ignition Switch – Used to START the generator.
3. EZ Start Dial – Used to start, stop and choke the generator.
4. Circuit Breakers (Push Reset) – Protects the generator
against electrical overloads.
5. Ground Terminal – Consult an electrician for local grounding
regulations.
6. Parallel Outlets – Used to parallel two inverters together for
increased power output. (parallel kit sold separately).
4
C
3
4
A
5
(2×) 120V AC, 20A (NEMA 5-20R)
C
May be used to supply electrical power for
A
operation of 120 Volt AC, 20 Amp, single phase,
60 Hz electrical loads.
120V AC, 30A Locking (NEMA L5-30R)
W
May be used to supply electrical power for
B
operation of 120 Volt AC, 30 Amp, single phase,
60 Hz electrical loads.
12V DC, 8A (Regulated Automotive)
z
C
May be used to supply electrical power for
operation of 12 Volt DC, 8 Amp electrical loads.
Do not operate a device while it is plugged into the 12V DC
outlet. When charging a device, do not place on the exhaust
side of the generator. Extreme heat caused by exhaust
can damage the device and cause a potential fire hazard.
Prolonged exposure to engine exhaust can cause serious injury
or death.
15
CONTROLS AND FEATURES
6
RECEPTACLES
WARNING
