Table of Contents
Advertisement
RSS-GEN Sections 7.1.4 and 7.1.5 Statement for Devices with Detachable
Antennas
This device has been designed to operate with the antennas listed in the Certificate,
and having a maximum gain of 5 dBi. Antennas not included in this list or having a
gain greater than 5 dBi are strictly prohibited for use with this device, unless system-
level FCC approval is gained. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (EIRP) is not
more than that required for successful communication.
Integration Note
a) This module is authorized under limited module approval specified to mobile host
equipment. So, the antenna must be installed such that 20cm is maintained between
the antenna and users.
b) The transmitter module may not be co-located with any other transmitter or
antenna.
As long as the two conditions above are met, further transmitter testing will not be
required. However, the OEM integrator is still responsible for testing their end product
for any additional compliance requirements required with this module installed (for
example, digital device emission, PC peripheral requirements, etc.)
Note:
laptop configurations, general purpose PCMCIA or similar cards, or co-
location with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID cannot be used on the final product
(including the transmitter) and obtaining a separate FCC authorization.
Note:
void the user's authority to operate this device.
Revision Table
Date
March 2007
June 2007
June 2008
December 2011
MatchPort b/g Integration Guide
In the event that these conditions cannot be met (for example certain
Changes or modifications to this device not explicitly approved by Lantronix will
Rev.
Comments
A
Initial Draft
B
Updated content related to demo board jumper configuration,
recommended operating conditions, technical specifications
and the PCB interface signal.
C
Updated the RoHS table, configuration switch bank, and
tolerance information.
D
Updated absolute maximum ratings and recommended
supply voltage information.
3
Advertisement
Table of Contents
