Star Commands For Phone Operation; Set Up - Hybertone HT-822P User Manual

Http://www.hybertone.com
kind of star command is shown in the table below.
Star(*) Command
*01
*02
*03
*04
*20
*09987456
*11983185922
Note: These commands are factory preset and cannot be modified.

3.1.2 Star Commands for Phone Operation

The star commands for phone operation are 3-digit long at least and some contains
operands. These star commands are shown in the table below.
Star(*) Command
*12
*21
*42
*41
*50

3.2 Set up

The setup of the HT-822P IP ADAPTOR can be done via auto-provisioning if the service
provider supports this feature. Local setup is supported via built-in web pages. To access
the web pages, the LAN or PC port IP address is required. The HT-822P IP ADAPTOR is
equipped with voice prompts to read LAN port and PC port IP addresses via the Phone 1
HT-822P VoIP FXS+PSTN Gateway
Function
Read LAN Port IP
Read PC Port IP
Set LAN Port IP. Pick up the handset, press
*03, and then follow the instruction of the
phone to set the IP address.
Set PC Port IP. Pick up the handset, press
*04, and then follow the instruction of the
phone to set the IP address.
Send a remote support request.
Reset IP:
LAN Port IP:
192.168.0.1 (The new terminal are DHCP
default)
PC Port IP:
192.168.8.1(The new terminal are Fixed
Mode.)
Reset system configuration. Return to the
default configuration.
Function
Switch to VOIP line
Switch to PSTN line
Hold the current call / Release the Hold call
Call Transfer to another VoIP Number
Phone book function key
8