Seima Limni Wall Faced Toilet Suite STO-309 Installation Manual

Installation Guide
Limni Wall Faced Toilet Suite
CISTERN PACKAGE CONTENTS
1 x ceramic cistern lid
1 x ceramic cistern base
Cistern is supplied with flush
valve and dual purpose inlet
valve already installed.
PAN PACKAGE CONTENTS
1 x ceramic pan
seima.com.au
IMPORTANT
1
2
3
4
2 x bolts w seals 2 x plugs
For attaching Plugs can be used to
cistern to pan. plug holes in sides of
pan if required.
Threaded
section can be
trimmed to
required size.
1 x pan connector
For connecting pan to
floor outlet pipe/S-trap.
1 x threaded section
(with flange plate)
Flange attaches to wall;
threaded section links to
pan connector.
Please note
− Installation shall be in accordance with AS/NZS3500.
− All measurements are in millimetres. Height dimensions
are to base of pan. Make allowance for bedding.
− Bedding: Pan may be bedded with cement base or using
silicone sealant. Fix pan to floor using a sand cement
mixture of 3:1 to a depth of 60mm. Do not use lime or
fast-drying cement.
Inspect the components before installation to ensure there are no visible
defects. If a defect is found, do not install the toilet suite and contact the
supplier immediately. Claims for defects will not be accepted after the product
has been installed.
This toilet suite is suitable for a variety of set-ups:
Cistern — accommodates either Back Entry Inlet connection or Bottom Entry
Inlet connection (left or right stop valve).
Pan — universal trap — accommodates S-trap installation or P-trap installation
(using appropriate connector; not supplied).
The toilet suite must be installed by a licensed plumber. Failure to do so may
void the warranty.
Installation must be in accordance with AS/NZS3500.
1 x rubber seal
For sealing outlet at
base of cistern.
Large end of pan connector
can be trimmed to suit setout.
2 x concealed
fixing brackets
Optional — can be
used to connect
pan to floor.
1 x flush button
Half flush left, full
flush right.
2 x floor bolts 2 x caps (chrome plated)
(+ white plugs) 2 x screws
2 x washers 2 x pan plugs (white)
Optional fixing #2 —
Optional fixing #2 — used to
used with fixing brackets
secure pan to concealed fixing
to secure pan to floor.
bracket. Plastic plug is placed
Bolt is inserted through
into hole in side of pan exterior,
bracket base hole.
screw is rebated into plug
and then screws into a hole
in upright section of bracket.
Chrome cap is used to cover
plastic plug.
− Bracket fixing: The pan should be bedded with silicone
sealant and fixed with the brackets supplied.
− Do NOT use epoxy type adhesives.
− Dimensions are nominal and subject to normal ceramic
manufacturing variations.
− Specifications may vary without notice as part of our
continuous improvement practices.
− Clean with a damp cloth. Do not use abrasive cleaners,
liquids or pastes.
Note: The cistern can
be adapted for bottom
entry plumbing. The
bottom entry inlet
valve shown above is
an optional extra.
limni-wf-in | v 3.0 | page 1 of 4