To Heat Properly; Trumatic C Hot-Air Heater - Globecar 2 Win Instruction Manual

10
Appliances
10.2.1
Hot air distribution
Adjusting the air outlet
nozzles
10.2.2
Operating modes
Selecting operating mode:
64

To heat properly

Fig. 53 Air outlet nozzle
Several air outlet nozzles (Fig. 53) are built into the vehicle. Pipes conduct the
warm air to the air outlet nozzles. Turn the air outlet nozzles in a suitable posi-
tion so the air can escape as required. To avoid draft close the air outlet noz-
zles on the dashboard and set the air distribution of the base vehicle to air
circulation.
Fully open: Full hot air stream
Half or partially open: Reduced hot air stream
When five air outlet nozzles are completely opened, less warm air escapes
through each nozzle. However, if only three air outlet nozzles are opened,
more warm air flows out of each nozzle.

Trumatic C hot-air heater

When there is a danger of frost the heater is not in operation, empty the
heating system.
Do not use the space above and behind the heater as a storage compart-
ment.
Fig. 54 Operating unit for heater/boiler
The heater has two operating modes:
Winter operation
Summer operation
It is only possible to heat the vehicle in the "Winter" operating mode. With the
"Summer" operating mode only water in the boiler is heated. It is not possible
to heat the vehicle in this operating mode.
Set the operating mode using the rotary switch (Fig. 54,3).
1 Temperature control knob
2 Summer operation water tempera-
ture 40 °C or 60 °C
3 Rotary switch
4 Off
5 Winter operation "Heater without
boiler"
6 Winter operation "Heater and boiler"
7 Green indicator lamp "Heating opera-
tion"
8 Red indicator lamp "Fault"
9 Yellow indicator lamp "Boiler heating-
up phase"
Reisemobil - 06/02-2 - GLO-0005-00EN