Table of Contents
Advertisement
4.1.3
4.2.1
Operating switch
Reisemobil - 06/02-2 - GLO-0005-00EN
The calculation of the payload from the difference between the maximum per-
missible gross weight in laden condition and the mass specified by the manu-
facturer in ready-to-drive condition is however only a theoretical value.
Only if the vehicle is weighed with full tanks (fuel and fresh water), full gas bot-
tles and complete additional equipment on a public weighbridge, can the
actual payload be determined.
Loading the motorhome correctly
Distribute the load evenly on the left and right sides of the vehicle.
Distribute the load evenly on both axles. In doing so, observe the axle
loads specified in the vehicle documents. Observe the permissible load-
carrying capacity of the tyres.
Store all objects in such a way that they cannot slip.
Store heavy objects (tent poles, tin cans, etc.) close to the axles.
Low-lying storage compartments whose doors do not open in the direc-
tion of travel or underfloor storage compartments are particularly suited
for storing heavy objects.
Stack light objects (laundry) in the roof storage cabinets.
4.2
Entrance step
Before commencing the journey and after short interruptions of the
journey, ensure that the entrance step is completely retracted.
Do not stand in the direct range of the entrance step while it is being
retracted or extended.
Do not step on the entrance step until it has extended completely. There
is a risk of injury.
Do not under any circumstances raise or lower persons or loads with the
entrance step.
Do not grease or lubricate the pivot bearing and joints of the entrance step
(see chapter 12).
Electrically operated entrance step
The switch (Fig. 1,2) to operate the entrance step is located on the inside of
the vehicle in the area of the conversion door.
Before the journey
4
19
Advertisement
Table of Contents
