Advertisement
ASSEMBLY
9
Place Dowels
3
in the 2 indicated holes
between the Cam Bolts
Middle Shelf
F
.
Insert the installed Dowels and Cam Bolts into
the corresponding holes in the top edge of the
Bottom Divider
G
.
Secure by inserting a Cam Nut 2 into each of
the adjoining holes in the side of the Bottom
Divider. Use a Phillips-head screwdriver to turn
the Cam Nuts clockwise to secure the Cam
Bolts.
Hardware Required:
10
Install Runners
7
Fully extend one Runner and align the inner section along one set of 3 small holes on the Left Side as
shown. Verify that the orientation of the Runner matches the diagram, then fasten the Runner to the Divider
using 3 Screws
8
Attach the second Runner to the same Divider following the same method, checking orientation before
inserting Screws.
Follow the above instructions to attach 2 Runners to the Right Side.
Hardware Required:
8
FRONT
7
B
Insert Cam Bolts
Cam Bolts into the panels.
Attach Foot Pads
Hardware Required:
1
in the bottom of the
2
Cam Nut x2
3
Dowel x2
on the Left Side
B
and Right Side
positioned as shown. Once the Runner is attached, slide it back to the closed position.
7
Runner x4
Screw (3x12mm) x12
8
1
1
1
1
into the 6 indicated holes on each Side. Use a Phillips-head screwdriver to tighten the
?
to the bottom of all 4 legs. Press firmly to adhere.
1
Cam Bolt x12
Foot Pad x4
?
F
C
.
BACK
BACK
2
G
3
FRONT
1
C
1
H
8
7
1
8
Advertisement
