Advertisement
ASSEMBLY
1
Install Runners
7
Fully extend one Runner and align the inner section along one set of 3 small holes on the Left Divider as shown.
Verify that the orientation of the Runner matches the diagram, then fasten the Runner to the Divider using 3
Screws
8
positioned as shown. Once the Runner is attached, slide it back to the closed position. Attach the
second Runner to the Right Divider following the same method, checking orientation before inserting Screws.
Insert 2 Cam Bolts
screwdriver to tighten the Cam Bolts into the panels.
Hardware Required:
BACK
1
D
2
Install Runners
7
on both sides of the Bottom Divider
both Runners should extend in the same direction.
Hardware Required:
BACK
on the Left Divider
D
and Right Divider
into the indicated holes above the Runners on each Divider. Use a Phillips-head
1
1
Cam Bolt x4
7
Runner x2
Screw (3x12mm) x6
8
FRONT
7
8
7
Runner x2
Screw (3x12mm) x6
8
8
7
E
.
8
8
7
E
G
using the method described in Step 1. When installed,
BACK
G
FRONT
ASSEMBLY NOTE: Use a Phillips-
head screwdriver to tighten each
Cam Bolt you install until its
threads are fully inserted.
FRONT
1
FRONT
7
BACK
8
5
Advertisement
